plop project
-
- Posts: 80
- Joined: Mon Dec 19, 2016 11:58 am
- Rides:: retro's
- Location: matlock
-
- Posts: 80
- Joined: Mon Dec 19, 2016 11:58 am
- Rides:: retro's
- Location: matlock
Re: plop project
Need a new carb.
anyone tell me if these are any good ?
http://www.ebay.co.uk/itm/New-Honda-C90 ... SwxCxT6cim
anyone tell me if these are any good ?
http://www.ebay.co.uk/itm/New-Honda-C90 ... SwxCxT6cim
- Alan CF
- Posts: 6758
- Joined: Mon May 09, 2011 6:10 pm
- Rides:: CUB RACING small cc engine rebuilds crank repairs
- Location: CHESTERFIELD
Re: plop project
Should be ok, But i think your loosing 1mm on the Ventura.
C90 Class
1. Max 90cc. No big-bore kits
2. Standard Keihin PB type carb (max 15mm slide / 19mm exit) and standard Honda C90/C70 inlet manifold only.
3. Standard design 2 valve single OHC cyl head only
4. 3-Speed semi-auto clutch only
C90 Class
1. Max 90cc. No big-bore kits
2. Standard Keihin PB type carb (max 15mm slide / 19mm exit) and standard Honda C90/C70 inlet manifold only.
3. Standard design 2 valve single OHC cyl head only
4. 3-Speed semi-auto clutch only
-
- Posts: 80
- Joined: Mon Dec 19, 2016 11:58 am
- Rides:: retro's
- Location: matlock
Re: plop project
did notice its 18mm and not 19mm but it is origanal and that is what the rules states. I have 3 carbs here but they all have bits missing and in a state i wouldnt want to use.
-
- Posts: 80
- Joined: Mon Dec 19, 2016 11:58 am
- Rides:: retro's
- Location: matlock
Re: plop project
By the way will be in the open class.
-
- Posts: 80
- Joined: Mon Dec 19, 2016 11:58 am
- Rides:: retro's
- Location: matlock
-
- Posts: 80
- Joined: Mon Dec 19, 2016 11:58 am
- Rides:: retro's
- Location: matlock
-
- Posts: 1289
- Joined: Thu May 27, 2010 2:47 pm
- Rides:: several honda c90's c70 and c50, lambretta li special puch and a honda cbf
- Location: sheffield
Re: plop project
Looks good Fazey,what exhaust you going to use ?
-
- Posts: 80
- Joined: Mon Dec 19, 2016 11:58 am
- Rides:: retro's
- Location: matlock
Re: plop project
Not got an exhaust yet. need to get hold to something. would like a race exhaust but we dont have a big budget.
- Ventura
- Posts: 621
- Joined: Thu Nov 24, 2011 8:46 pm
- Rides:: '91 C90, '73 ST70 & Z50, '76 TL125, '80 Bultaco 250, '16 Yam XSR900,
- Location: Merseyside
Re: plop project
Lookin' good so far Fazey!fazey wrote: Not quite finished yet but its on and working.
Please let me know if i'm missing something..
You may need to brace the anchor point a bit to stop it flexing under full braking load.
V.